The rider is allowed to ride a bicycle on the approved road.
In case of obstacles, please carry the bicycle.
In case of damage, please inspect the bicycle at the distributor.
Request the distributor to replace the damaged, bent or loose reflector and the light.
Inspect the reflector and the light regularly.
Avoid severe injury caused by damaged parts
The motor, crank or bottom bracket may be damaged while riding a bicycle in the country-
side or on the curb, and consequently severe injury may be caused.
The reflector can capture and reflect light of street light, car headlight and other light sources
so that the rider is easy to identify. The rider may be hard to identify if the reflector is
damaged, bent or loose and consequently severe injury or death will be caused.
To avoid such accidents, you should:
Avoid severe injury or death caused by damage or looseness of reflector and
light
Please be sure to adjust the riding speed as appropriate.
Replace parts or add accessories appropriately in order to avoid severe injury or death.
Please be sure to consult the distributor before installation, use and maintenance of
components.
Please be sure to read and comply with the instructions attached.
Only activities set forth in the maintenance plan can be carried out.
Only commercially available lubricant and detergent can be used.
Only qualified distributor can carry out maintenance and repair.
If the speed is not controlled properly while riding in the countryside or in the sidewalk, the
rider may fall down and consequently severe injury or death may be caused.
Improper maintenance, repair and cleaning may result in severe injury or death.
Inspect wear of all parts (such as brake block and tire) regularly.
Qualified distributor/specialist shall replace (if possible) or repair the damaged parts.
The bicycle and parts thereof will be worn (scratch, crack, wear and color change). The
damaged parts may break down suddenly and consequently injury and death may be
caused.
Please be sure to store the bicycle in a well-ventilated room.
Cool hot parts down before use or wear thermal protection device.
Brand new materials (such as oil paint) and high-temperature motor will produce volatile
gases. Volatile gases will gather when the bicycle is stored indoors and consequently difficult
breathing and suffocation may be caused.
Parts of the bicycle (brake and tire) may heat up during riding and burn injury may be caused
by touching these parts.
In this case, please inspect the bicycle at the distributor immediately.
If necessary, install an ergonomic saddle suitable for women/men.
When necessary, adopt preventive measures.
The legs may be injured (relating to Q value) if the space between the pedals is too small.
The rider may feel uncomfortable with the pedals.
The bicycle can be used on the approved road only.
In case of crack or obvious damage, please consult the distributor/specialist about mainte-
nance.
Inspect whether the parts makes a correct response (e.g.: Shift the gear on a flat surface)
and whether they function well before riding.
The rider is allowed to ride a bicycle on the approved road only.
The motor may work abnormally in case of improper assembly, wear and overload (e.g.: The
motor is powered in the bumpy pavement and on the curb) or loose parts.
Men may have prostatic diseases after sitting on the saddle long and frequently.
Please be sure to supply sufficient liquids. Please inspect the bicycle at the distributor.
Riding is a strenuous physical activity.
Please be sure to wear suitable clothes in cold weather, including face shield, mask and
gloves.
Please be sure to test power function before initial riding.
Please be sure to wear personal protective equipment.
Please be sure to inspect default speed settings of the bicycle.
Please be sure to thoroughly inspect braking force, speed and function before riding.
Cold injury may be easily caused while riding in cold weather
The bicycle may be out of control and overturned due to sudden power.
Abandon waste batteries and electrical/electronic components of the bicycle according to
laws and regulations.
Please comply with the manufacturer’s instructions during operation.
Ensure batteries are not fully discharged.
The batteries can be stored in a dry place only.
Please charge the batteries at least once every half year.
The damaged parts (such as battery and electrical or electronic components) of the bicycle
may produce toxic substances or gases and consequently environmental poisoning may be
caused.
Property losses may be caused by improper use of battery.
Many components and accessories can improve comfortableness, performance and
appearance of bicycle. The risk of adding components or accessories shall be borne by the
user, since such components or accessories may not pass the test on compatibility, reliability
or safety conducted by the manufacturer. Uncertified compatibility, reliability or safety and
improper installation, use and maintenance of components or accessories of bicycle may
result in severe injury or death.
Avoid severe injury incurred while riding in the countryside or on the curb
Avoid injury in the legs
Avoid vibration
Avoid severe injury or death caused by damaged parts
Avoid severe injury caused by improper maintenance, repair and cleaning
Avoid difficult breathing and suffocation
Avoid burn injury
Avoid injury or uncomfortable experience
Avoid dehydration while riding
Avoid cold injury
Avoid falling down due to sudden power
Environmental issues
Avoid material damage
To Next Page
Loading...
