INTRODUCTION | PAG. 3
1. INTRODUCTION
The M6 control unit is an electronic monitoring, control and protection controller
for generator sets.
The general characteristics are as described below:
1. Supply voltage 8/36V.
2. Start and mode selection key.
• “AUTO” mode. Start activated through an external start input via volt
free contact ( LT)
• “MAN” mode. Start activated by the user.
3. 14 LEDs for visual indication of the status of the control unit.
4. 2 control unit command buttons:
• Push button to “start” / “stop” the generator set.
• “RESET” button to reset the control unit when an alarm is detected.
5. Start by voltage free contact ( LT ) in “AUTO mode”.
6. Motor protection features:
• Fuel reserve.
• Battery charging failure.
• High motor coolant temperature.
• Low oil pressure.
• Auxiliary motor alarm.
• Overspeed eding:
• Due to electrical signal frequency of generator.
• Due to motor pick up.
7. Shortcircuit and temperature selfprotected transistor outputs:
• 3 power outputs (40A).
• 4 signal outputs (1A).
8. USB port.
To Next Page
Loading...
Need help?
General
