Hioki 3159 - Page 6

5
(1)
(2)
(3) Inspection Result
The 3159 will beep and will be displayed on the screen.
Abnormal: will be displayed on the screen. (Perform steps (4) and (5), then follow the instruction
below.)
(4)
(5)
(6)
Wear high-voltage rubber gloves when connecting the lead wires.
Turn the output voltage knob clockwise during
the (70 second) test.
During the inspection, you do not need to adjust
the voltage accurately. As a general guide, turn
the knob about a quarter turn.
Disconnect the test leads (short-circuited part).
The startup inspection is now complete.
When a test is started, high voltage is generated by
the 3159 when it enters the state.
Do not touch the output voltage HIGH terminal (red)
or the test lead while the lamp is
illuminated.
Press the START key to start the test.
Press the STOP (EXIT) key to cancel the hold state.
* Check the test lead connections (insertion/tightening) and test again. If the result is still “PASS,” a test lead may be
damaged or the 3159 may be malfunctioning. Please contact your authorized Hioki distributor or reseller.
Turn the output voltage knob all the way
counter-clockwise, returning it to zero. Turn the
main power switch of the 3159 off.
Normal:
4. Simple Startup Inspection (Check)