Installation EAGLE20/30
Release
06
04/2014
35
Note: In general, adhere to the following recommendations for data cable
connections in environments with high electrical interference levels:
Keep the length of the data cables as short as possible.
Use optical data cables for the data transmission between the buildings.
When using copper cables, provide a sufficient gap between the power
supply cables and the data cables, when laid over a long distance. Ideally,
install the cables in separate cable channels.
Use shielded cables.
Connect the data cable according to your requirements.
2.7.3 100/1000 Mbit/s F/O port
Note: Make sure that you connect LH ports exclusively with LH ports, SX
ports exclusively with SX ports, and LX ports exclusively with LX ports.
Connect the data cable according to your requirements.
2.8 Insert data in label area
The information field for the IP address on the front of the device helps you
identify your device.
To Next Page
Loading...
Need help?
General
