Hirschmann OZD Profi 12M G11 - Setting the Operating Mode and Transmitting Power; Setting the Operating Mode of the Electrical Ports (CH1, CH2)

Installation OZD Profi 12M ...
Release 01 07/2017
43
4.4 Setting the operating mode and
transmitting power
Note:
– S1 does not have a function on OZD Profi 12M ... with only one electrical
interface.
– S7 does not have a function on OZD Profi 12M ... with only one optical
interface.
The following details only apply for the S8 default position (S8 = 0).
 The DIP switch S0 is used to set the operating mode of the electrical port
CH1.
 The DIP switch S1 is used to set the operating mode of the electrical port
CH2.
 This applies exclusively to device variants OZD Profi 12M x22:
The DIP switches S2 and S3 are used to set the operating mode of the
optical port CH3.
 The DIP switches S4 and S5 are used to set the operating mode of the
optical port CH4.
4.4.1 Setting the operating mode of the electrical ports
(CH1, CH2)
 Operating mode: electrical ports (CH1, CH2) with segments
monitoring
CH1 is activated in this operating mode if S0 is in Position 0.
Applies to device variants with 2 electrical ports:
CH2 is activated in this operating mode if S1 is in Position 0.
CH 3
CH 4
CH 3
CH 4
CH 1
CH 2
10
S
1
S
0
S
6
S
5
S
3
S
2
S
4
S
7
S 8
CH 3
CH 4
CH 3
CH 4
CH 1
CH 2
10
S
1
S
0
S
6
S
5
S
3
S
2
S
4
S
7
S 8