4.1 Safety notice
15
4 Setting Up
Version 2.4 04/07
4 Setting Up
Only use the OZD Profi 12M … as described in
this ”Description and Operating Instructions“.
Pay particular attention to all the warnings and
safety instructions.
Only operate the modules with a safety extra-low
voltage in accordance with IEC 950/EN 60 950/
VDE 0805 with a maximum rating of +32 VDC
(typically +24 VDC).
The power source must comply with NEC, Class 2,
regulations as stipulated by UL/CSA.
Pay attention to the electrical limit values when
connecting the power supply to the signaling
contacts:
max. voltage 60 VDC, 42 VAC.
The connected power supply must also be safety
extra-low voltage in accordance with IEC 950/
EN 60 950/ VDE 0805 and comply with NEC,
Class 2, regulations as stipulated by UL/CSA.
DANGER: Never connect the OZD Profi 12M … to
the main power supply.
Only install the device in a location where the
climatic and mechanical limit values given in the
Technical Data can be complied with.
WARNING: Do not look directly into the aperture of
the optical transmitting diode or the optical fiber.
The light beam which is emitted could endanger
your eyesight.
WARNING: All OZD Profi 12M … are approved for
use in Zone 2 explosive hazardous areas as defined
by EEx nC [L] IIC T5. If used in those areas, the
modules must be installed in a housing (switch
cabinet) with protection class IP 54 as per IEC 529.
4.1 Safety notice
OZD Profi 12M P11
OZD Profi 12M P12
OZD Profi 12M G11-1300
OZD Profi 12M G12-1300
OZD Profi 12M G12-1300 EEC
The optical radiated power of the components used in this device does not
represent a potential health hazard of any description under normal, fore-
seeable conditions, and it complies with Class 1 in accordance with IEC
60825-1:1994+A1:1997 resp. the Degree of Endangerment 1 in accordance
with IEC 60825-2:1993.
OZD Profi 12M G11
OZD Profi 12M G12
OZD Profi 12M G12-EEC
Non-visible LED radiation.
Do not look into the beam, not even with optical instruments. LED class 1M.
Classification according
IEC 60825-1:1993+A1:1997+A2:2000.
To Next Page
Loading...