8.1 FCC conformity
35
8 Appendix
Version 2.4 04/07
8.1 FCC conformity
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help.
8 Appendix
8.2 FM approval
FM 3611
9
INDUSTRIAL CONTROL EQUIPMENT
FOR USE IN
HAZARDOUS LOCATIONS
CLASS I: DIV. 2
GROUP A; B; C AND D
T5: T
A
: O °C … 60 °C
8.3 Ex approval
8
II 3 G
EEx nC [L] IIC T5
KEMA 00 ATEX 1141 X
8.4 UL/CSA approval
1
UL 1950/CSA 950
File Nr. E 168 643
To Next Page
Loading...