4.5 Installation
23
4 Setting Up
Version 2.4 04/07
Mounting on a hat rail
䊳
Hang the top snap-in hooks of the module into the hat
rail and press the underside onto the rail (as shown in
Fig. 7) until it audibly clicks in.
䊳
To remove the module, pull down on the locking slide.
Mounting on a mounting plate
The modules have three through-holes. This allow it to be
mounted on any flat surface, e.g. on the mounting plate
of a switch cabinet.
䊳
Drill three holes in the mounting plate corresponding
to the drilling template in Fig. 8.
䊳
Secure the modules with machine bolts
(e.g. M 3 x 40).
䊳
Ensure that there is a reliable electrical connection
between the module housing and the mounting plate.
Place toothed washers under the bolt heads to pierce
the varnish.
To Next Page
Loading...