What to do if the warning indicator light flashes 4 times on my Hisense C1 Projector?
If the warning indicator light on your Hisense Projector is flashing 4 times, it could be due to a communication failure between the display board and the TV board. Try reinserting or replacing the cable. Alternatively, the display board or the mainboard might have failed, requiring replacement.
What to do if the warning indicator light flashes 3 times on my Hisense C1?
If the warning indicator light on your Hisense Projector is flashing 3 times, it may indicate a DLP system failure. Try reinserting or replacing the FFC. It could also be due to the DMD part not being correctly installed, a DMD failure, or a DMD board failure; try reassembling or replacing the DMD or DMD board. Another potential cause is a display board failure, which would require replacing the display board.
Why is the warning indicator light flashing 2 times on my Hisense C1?
If the warning indicator light on your Hisense Projector is flashing 2 times, it might be because the fan speed is slow or the fan has stopped spinning. Try cleaning the fan. If the fan is broken, you'll need to replace it. A poor fan transmission could also be the issue, in which case the display board should be replaced.
How to fix a Hisense C1 when the warning indicator light flashes 1 time?
If the warning indicator light on your Hisense Projector is flashing once, it could mean that the NTC temperature exceeds the protection temperature. Try removing any shield or reducing the ambient temperature. It could also be due to NTC failure or poor plug-in. If shutdown cooling is at 25 degrees and the measurement value is about 10K, the NTC is likely fine. However, if the resistance value is too large or too small (an obvious open or short circuit), the NTC is bad and needs to be replaced.
General safety precautions for servicing the mini projector, emphasizing manufacturer-specified parts and experienced technicians.
Critical safety warnings regarding electrical shock, ESD, and proper grounding during repair procedures.
Important notes and instructions for ensuring safety and proper work procedures during servicing.
Step-by-step guide on how to access the projector's hidden factory menu using the remote control.
Overview of the factory OSD menu, cautioning users about potential data changes.
Details and settings available within the Factory Option menu, including version and MAC addresses.
Configuration options related to laser settings, such as runtime, alarm, and display upgrades.
Information on the software versions of various components like TCON, FRC, and DLP.
Section detailing the 'Write keys' settings, often related to licensing or regional configurations.
Procedure for clearing the EEPROM data in the factory mode, often used for resetting settings.
Method for upgrading software via USB when the projector is in normal user mode.
Procedure for upgrading software via USB when the projector is in factory mode.
Explanation of different LED flash patterns and their corresponding fault determinations.
Notes that the display board does not have an LED indicator.
Describes specific operational procedures, including eye protection and auto-correction features.
Details the projector's eye protection function, its automatic operation, and how to enable/disable it.
Instructions for using automatic keystone correction and auto focus features for optimal picture display.
Function of the power indicator light, including normal operation and error reporting.
Explains the automatic dust removal function, its frequency, and operation.
Details the projector's temperature protection mechanism and prompts for overheating.
General| Display Technology | DLP |
|---|---|
| Resolution | 4K UHD (3840 x 2160) |
| Brightness | 1600 ANSI Lumens |
| Throw Ratio | 1.2:1 |
| HDR | HDR10 |
| Connectivity | Bluetooth, Wi-Fi, USB |
| Lamp Life | 25000 hours |
| Screen Size | 60" - 150" |
| Native Resolution | 3840 x 2160 (4K UHD) |
| Projection Size | 60" - 150" |
| Speakers | 10W x 2 |
To Next Page
