5
discharges (ESD). Careless handling during repair can reduce life drastically.
When repairing, be sure to use anti-static table mats and properly use a
grounding wrist strap. Keep components and tools also at this same potential.
IMPORTANT:
Always disconnect the power cord from AC outlet before replacing parts or
modules.
1.2.2 Warning 2
To prevent electrical shock, use only a properly grounded 3 prong outlet or
extension cord.
1.2.3 Warning 3
Safety regulations require that after a repair the set must be returned in its
original condition. In addition, prior to closing set, check that:
-Note:
>All wire harnesses and flex cables are properly routed and secured with
factory tape and/or mounted cable clamps.
> All cables and connectors are properly insulated and do not have any bare
wires/lead exposed
1.2.4 Warning 4
(1) Do not supply a voltage higher than that specified to this product. This may
damage the product and may cause a fire.
(2) Do not use this product:
> High humidity areas
> In an area where any water could enter or splash into the unit. High humidity
and water could damage the product and cause fire.
(3) If a foreign substance (such as water, metal, or liquid) gets inside the panel
module, immediately turn off the power. Continuing to use the product may
cause fire or electric shock.
(4) If the product emits smoke, and abnormal smell, or makes an abnormal
sound, immediately turn off the power. Continuing to use the product, it may
cause fire or electric shock.
(5) Do not pull out or insert the power cable from/to an outlet with wet hands. It
may cause electric shock.
(6) Do not damage or modify the power cable. It may cause fire or electric shock.
(7) If the power cable is damaged, or if the connector is loose, do not use the
product: otherwise, this can lead to fire or electric shock.
(8) If the power connector or the connector of the power cable becomes dirty
To Next Page
