Hisense ERF3A80 - Installing the Stand or Wall Mount Bracket

2
Installing the Stand or Wall mount bracket
1. Carefully place your TV face-down on a soft, flat surface to prevent damage to the
TV or scratching to the screen.
2. Take out the 2 stands from the accessory bag and then insert the stands into the
bottom slots of the TV.
3. Secure the stands to the TV with the 4 screws in accessory tightly.
Installing the stand
CAUTION
Be sure to disconnect the AC power cord before installing a stand or wall mount
brackets.
The display on your TV is fragile. Make sure the TV screen is not scratched or
damaged by hard objects or from pressure.
After the installation is completed, make sure the TV is steady on a table or firmly
attached to a wall mount, before removing all protective film, if any.
Follow the illustrations and textual instructions below to complete the installation steps:
Follow the illustrations and textual instructions below to complete the installation steps:
Screws:
M4×16 (43")
M4×12 (50"/55")
Base Stand
1. Carefully place your TV face-up on a soft, flat surface to prevent damage to the TV
or scratching to the screen.
2. Take out the 2 stands from the accessory bag and then insert the stands into the
bottom slots of the TV.
3. Secure the stands to the TV with the 4 screws in accessory tightly.
43"/50"/55"
58"