Hisense HCHM-N04X - Installation; Marking Of The Positions Of The Suspension Bolts And Wiring Connections; Mounting And Hanging The Switch Box

Suspension Bolt
(Field-Supplied)
Nut (Field-Supplied)
Washer with Insulation
(Field-Supplied)
Suspension Bracket
(Attached Indoor Unit)
Wa
sher (Field-Supplied)
Double-Nut
(Field-Supplied)
(1-3/16 to
1-15/16 inch)
30 to 50mm
Suspension Bolt
Suspension Bracket
(Four Places)
4.4 Installation
Figure4.4Suspension
Figure4.5HangingMethod
4.4.2 MountingandHangingtheSwitch Box
(1) Placenutsandwashersontothesuspension
boltsbeforeinstallingtheSwitch Box.
NOTE:
Makesuretousewashersforinstallingthe
suspensionboltstothesuspensionbrackets.
Installthewasherwiththeinsulationside
facingdownforsuspendedinstallation
applications.Thisway,thewashers
themselvesremaininpositiononthe
suspensionboltsduringtheinstallation
phase.
Field-SuppliedParts
* SuspensionBolt: 4-M10orW3/8
* Nut: 12-M10orW3/8
* Washer: 4-M10orW3/8
* WasherwithInsulation:4-M10orW3/8
(2) HangingtheSwitch Box
(a) HangtheSwitch Boxbyputtinghandson
the bottomofthecabinet.
(b)
(c)
Insertthesuspensionboltintothegroove
partofthesuspensionbracketasshown
inFigure4.5.Ensurethatthewashers
arecorrectlyaffixedtothesuspension
bracket.
(d) KeeptheSwitch Boxleveltotheceiling
surface.IftheSwitch Boxisnotlevel,a
malfunctionmayoccur.
(e) Tightenthenutsofthesuspension bolt
withthesuspensionbracketafter
adjustmentiscompleted.
Adhesivemustbeappliedtothenutsin
ordertopreventthemfromloosening.
4.4.1 MarkingofthePositionsoftheSuspension
BoltsandWiringConnections
(1) Markthepositionsofthesuspensionbolts,
refrigerantpipingconnectionsandwiring
connection.
(2) Installationdimensionsareshownin
Figure2.1and2.2.
Afterthehangingwork,thepipingand
wiringconnectionworkisrequiredinside
theceilinginthegapbetweentheroof and
ceilingsoitisnotvisible.Therefore,
determinethedrawingdirectionofthe pipe
afterselectingtheinstallationlocation of
theSwitch Box.Beforedoingthehanging
work,carryoutthepipingandwiringwork
uptotheconnectingpositions.
10