■ ATV Manual Tuning
-In Analog signal source
Manual Install is only needed when analogue channels are not found with an automatic tuning.
● Press [▲/▼] to select ATV Manual Tuning, then press [►/OK] to enter ATV Manual Tuning menu.
● Press [▲/▼] to select search then press [◄/►] to being tuning.
● Storage - You can select the channel 1……100 .
● Color System - Select AUTO for automatic setup of the colour system. This television is compatible with PAL,
NTSC and SECAM systems.
● Audio System - Please select BG for Australia. Other options available are: I, DK and L.
● Current CH - You can select Current CH 1 to Current CH 100.
● Search - Auto search the channel.
● Fine-Tune - Fine adjusts for frequency to improve image under poor reception conditions.
● Press [RED] button to save the channel.
■ Program Edit
Use the SKIP button to mark channels that you want to skip automatically when using CH+/-. You can still select
the skipped channels using the number buttons.
● Delete channels: Use the [RED] button to delete the channels you have selected, once to select and twice
to delete.
● Rename channels: Use the [GREEN] button, [◄/►] and [▲/▼] to rename the channels you have selected.
● Move channels: Use the [YELLOW] button and press [▲/▼] to Move the channels to another position then
press MOVE a second time to finalize.
NOTE: "RENAME" and "MOVE" are for analogy TV channels only.
● Skip channels: Use the [BLUE] button to Skip the channels you have selected.
● FAV channels: Use the [FAV] button to add channels to the favorite list.
■ Signal Information
● This menu is used to check the signal strength of your antenna system. Usually strengths of above 75%
indicates an acceptable signal for your TV to display correct image. Each channel may vary in signal / quality
strengths and its common for broadcast strengths to change in your area. The signal strength of the channel
on the screen is displayed.
* If lower than 75% we advise to have your antenna system checked by qualified personal.