What to do if the light is not working in my Hisense Refrigerator?
Refer to replace LED lights in cleaning and care chapter. The control system may have disabled the lights because the door was kept open too long; close and reopen the door to reactivate the lights.
Why is my Hisense RS818N4TIE motor running continuously?
The motor may run continuously because the temperature setting is set colder than necessary. It is also normal to frequently hear the sound of the motor when a large quantity of warm food has recently been stored within the appliance, the temperature outside the appliance is too high, doors are kept open too long or too often, or after installing the appliance or it has been switched off for a long time.
What to do if my Hisense Refrigerator is not working correctly?
First, check whether the power cord is plugged into the power outlet properly. Then, check the fuse or circuit of your power supply, and replace it if necessary. Also, the ambient temperature might be too low; try setting the chamber temperature to a colder level. Finally, it is normal that the freezer is not operating during the automatic defrost cycle, or for a short time after the appliance is switched on to protect the compressor.
Why is the temperature inside my Hisense Refrigerator too warm?
The temperature inside your Hisense Refrigerator might be too warm because the doors have been left open too long or too frequently, an obstacle is preventing the doors from closing properly, or there's insufficient clearance around the sides, back, and top of the appliance.
Why is ice not dispensing from my Hisense RS818N4TIE?
If ice is not dispensing from your Hisense Refrigerator, consider these points: Ensure you waited 10 hours after installing the water supply line before making ice. Check that the water storage box is correctly installed and contains enough water. Verify that you haven't manually stopped the ice-making function. Inspect the ice maker bucket and chute for any ice blockage. If the freezer temperature is too warm, try setting it lower.
Why is the water dispenser not functioning on my Hisense RS818N4TIE?
There are a couple of reasons why the water dispenser on your Hisense Refrigerator might not be working. First, ensure the water storage box is installed correctly and has enough water. Next, check if the water line is broken, bent, or blocked. If the water storage box is frozen or the refrigerator temperature is too low, try selecting a warmer setting on the display panel. Finally, verify the water pump is working.
Why is the water dispenser not working on my Hisense RS818N4TIE?
If the water dispenser on your Hisense Refrigerator isn't working, start by checking if the water storage box is correctly installed and has enough water. Make sure the water line isn't broken or bent, ensuring it's unblocked and clear of obstructions. If the water storage box is frozen due to a low refrigerator temperature, try selecting a warmer setting on the display panel. Lastly, verify if the water pump is functioning.
Why is my Hisense Refrigerator ice maker not working?
If your Hisense Refrigerator is not dispensing ice, ensure you waited 10 hours after installing the water supply line before making ice. Check if the water storage box is correctly installed and contains enough water. Also, verify that you haven't manually stopped the ice-making function and that you've selected the Cubed or Crushed mode. Check for any ice blockage within the ice maker bucket or chute and ensure the freezer temperature isn't too warm by setting it lower.
Why is my Hisense RS818N4TIE Refrigerator dripping water on the floor?
If water is dripping on the floor from your Hisense Refrigerator, it could be due to several reasons. The water pan at the rear bottom of the cabinet might not be properly leveled, or the draining spout underneath the top of the compressor depot may not be correctly positioned to direct water into the pan. Also, the water spout could be blocked, or the refrigerator may have been powered off for a long time, causing ice in the bucket to melt and flow to the floor.
How to troubleshoot Hisense RS818N4TIE Refrigerator not working?
If your Hisense Refrigerator isn't working, check if the power cord is properly plugged into the outlet. Also, inspect the fuse or circuit of your power supply and replace it if necessary. If the ambient temperature is too low, try setting the chamber temperature to a colder level. Note that it's normal for the freezer not to operate during the automatic defrost cycle, or shortly after being switched on, to protect the compressor.
General| Display type | LED |
|---|---|
| Product color | Stainless steel |
| Product design | American door |
| Built-in display | Yes |
| Shelves material | Tempered glass |
| Appliance placement | Freestanding |
| Number of compressors | 1 |
| Fridge net capacity | 417 L |
| Fridge door balconies | 4 |
| Number of vegetable drawers | 2 |
| Fridge number of shelves/baskets | 3 |
| Noise level | 38 dB |
| Certification | CE, UKCA |
| Climate class | SN-T |
| Cooling system | Ventilated |
| Water supply type | Water tank |
| Total net capacity | 632 L |
| Water tank capacity | 4.5 L |
| Triple Cooling system | No |
| Star rating | 4* |
| Freezer position | Side-placed |
| Freezing capacity | 11 kg/24h |
| Freezer net capacity | 215 L |
| Storage time during power failure | 8 h |
| Cord length | 2 m |
| Power plug type | Type G |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 Hz |
| Energy efficiency scale | A to G |
| Annual energy consumption | 346 kWh |
| Package depth | 787 mm |
| Package width | 978 mm |
| Package height | 1860 mm |
| Package weight | 140000 g |
| Warranty period | 2 year(s) |
| Country of origin | China |
Weight and Dimensions| Depth | 730 mm |
|---|---|
| Width | 910 mm |
| Height | 1790 mm |
| Weight | 130000 g |
Guidelines for safe use by children and individuals with reduced capabilities, per EN and IEC standards.
Essential safety precautions for operating the appliance in various household and similar applications.
Critical safety measures related to the power cord, plug, socket, and voltage requirements.
Crucial steps and considerations for proper appliance installation, including connection and placement.
Guidelines for proper airflow around the appliance to ensure efficiency and heat dissipation.
Explanation of the control panel layout, icons, and their functions for operating the appliance.
Operation of ice maker control and temperature adjustment for the fridge compartment.
How to adjust freezer temperature and use of Super Freeze mode.
Using the dispenser for water, cubed ice, crushed ice, and related operational notes.
Common causes and solutions for the appliance not functioning as expected.
Solutions for problems related to continuous motor running, frost, incorrect temperatures, and doors not closing.
Troubleshooting steps for water leakage and issues with the ice dispensing function.
To Next Page