Ensure that:
All connections are tightly fixed.
Fault description table
Digital display
(if fitted on your machine)
Fault description
“Water supply fault”
“F03”
“Draining fault”
“F04” “F05” “F06” “F07”
“Electrical module”
“F13”
“UNB” “Unblance”
Error code
The appliance stops during the programme.
For models with a remaining time display, a failure code between “F01” to “F07”
and “F13”、“F14”or “UNB”appears on the display.
“F01”
Do not allow children to operate, crawl on, be near or inside your washer.
Note that during the wash cycles, the surface temperature of the porthole
d o o r m a y increase.
Close supervision of children is necessary when the appliance is used near
children.
Water level reaches overflow level.
Press the
“start/pause” button to cancel the failure code and start the
programme; if the fault per
sists,unplug the appliance and contact
After-Sales Service(see “After-Sales Service”).
If a failure code “F02” appears on the display:
If a failure code “F01” appears on the display:
“Door lock fault”
The appliance has none or insufficient water supply.
Check whether:
The water tap is fully open and there is sufficient water supply pressure.
Kinks are present in the water hose.
The mesh filters of the water supply are blocked (see “Care And Maintenance”
or “Mesh Filters for Water Connection”).
The water hose is frozen up.
After the problem has been removed, restart the programme by pressing “Start/Pause”
again; if the fault persists, unplug the appliance and contact After-Sales Service (see
“After-Sales Service”).
28
“
F14”
“Door unkock fault”
“F02”
“overflow or too much foam”
To Next Page
