Interactive Function (continued)
Using “StarBoard Software”
If you are using the “StarBoard Software” for the rst time, install it by following
the instructions in the manual located inside the bundled DVD-ROM.
For details on how to use the “StarBoard Software” and its functions, refer to the
bundled “StarBoard Software” DVD-ROM manual. The installation method is in
the menu of DVD which runs automatically when inserted to your computer’s drive
as follows: Browse Documents→Software, may lead you to a folder named in
different languages. Select your desired language and refer to the manual inside.
Before using this product, please read all manuals for this product.
We will not be liable for any matters related to the applications and manuals.
►Only use the DVD-ROM in a computer DVD drive. The DVD-
ROM is designed for computer use only. NEVER INSERT THE DVD-ROM
INTO A NON-COMPUTER DVD PLAYER! Inserting the DVD-ROM into an
incompatible DVD drive may produce a loud noise, which in turn MAY RESULT
IN EAR AND SPEAKER DAMAGE!
• After using DVD-ROM, please put it into DVD case and keep it. Please keep
the DVD neither in direct sunlight nor in a high temperature and high humidity
environment.
CAUTION
NOTE
• The information in the DVD-ROM is subject to change without notice.
• No responsibility is taken for any obstacle and defect to hardware and
software of your computer as a result of the use of the DVD-ROM.
• The pen is referred to as “Electronic pen” in the “StarBoard Software”.
• Notations in the “StarBoard Software” manual may differ from those in this
manual.
• Please regards the word "StarBoard" found in StarBoard Software manual,
online help, software message or any other related materials as the interactive
whiteboard system using the Hitachi Interactive Projector, or the projector.
("StarboardSoftware" is not changed).
• The set of functions that are available for the combination of Hitachi
Interactive Projector and Starboard Software is in conformity with the Starboard
FX Portable Series.
• Touch the blinking red part with the pen until it turns to a blinking green during
calibration. For more details on calibration, see the DVD of the StarBoard
Software.
To Next Page
Loading...
