--- 6 ---
Saw blade
Fig. 10
Fig. 11
Workpiece
Saw blade
Workpiece
Fig. 12
Saw blade
Oddly shaped
workpiece
Bevel cutting
Left bevel cutting
Left bevel cutting
Right bevel cutting
Right bevel cutting
Reference plane in and
(Surface of the workpiece
which contacts the fence)
Figures 10 and 11 show the right and left bevel
cutting by the Models C 10FSH and C 10FSB. More
accurate miter cutting is performed because the
same reference plane (surface of the workpiece
which contacts the fence) is used in both the left
bevel cutting and the right bevel cutting (Fig. 9).
Even an oddly shaped workpiece can be accurately
bevel-cut in either left or right by making the wide
and stable surface of the workpiece as the reference
plane as shown in Fig. 12. In addition, the working
efficiency is improved because there is no need to
turn around the workpiece.
Right bevel cutting
Left bevel cutting
Reference plane in and
(Surface of workpiece which
contacts the fence)
Reference plane in and
(Surface of the workpiece which
contacts the fence)
To Next Page
Loading...
Need help?
General
