Hitachi C 10FCH2

Other manuals for Hitachi C 10FCH2

Technical Data And Service Manual67 pages

Handling Instructions24 pages

Questions and Answers:

V
vpetersJul 26, 2025
What to do if my Hitachi C 10FCH2 will not start?
- I
  igonzalezJul 26, 2025
  If your Hitachi Saw won't start, there are several potential causes: 1. It might not be plugged in, so ensure it's properly connected. 2. A faulty switch could be the issue; in this case, have it replaced by an Authorized Service Center. 3. A blown fuse or tripped circuit breaker can prevent starting; replace the fuse or reset the breaker. 4. A damaged cord can also be the culprit; have it replaced by an Authorized Service Center. 5. Worn or broken brushes might be the problem; replace them to resolve the issue.
K
Keith WellsAug 1, 2025
How to improve cut quality of my Hitachi C 10FCH2?
- C
  Craig GarciaAug 1, 2025
  If your Hitachi Saw is making unsatisfactory cuts, consider the following: * The blade may be dull, so replace it. * The blade might be mounted backwards; turn it around. * There could be gum or pitch on the blade; remove the blade and clean it with turpentine and coarse steel wool. * You might be using the incorrect blade for the material; change the blade to the appropriate type.
K
Kevin BuckleyAug 7, 2025
What to do if the blade on my Hitachi C 10FCH2 Saw does not come up to speed?
- W
  Wyatt DelacruzAug 7, 2025
  If the blade of your Hitachi Saw does not come up to speed, it could be due to: 1. An extension cord that is too light or too long; replace it with an adequate size extension cord. 2. Low supply voltage; in this case, contact the electric company.
M
Mr. Aaron CarrAug 13, 2025
Why does my Hitachi C 10FCH2 vibrate excessively?
- K
  kimdanielsAug 13, 2025
  If your Hitachi Saw vibrates excessively, here are a few things to check: 1. Ensure the blade bolt is tightened securely. 2. Make sure the saw is securely mounted to the workbench by tightening all mounting hardware. 3. Reposition the workbench on a flat, level surface if it's on an uneven floor. 4. Clean the blade and blade flanges to remove any debris.
A
Anthony GreenAug 18, 2025
Why my Hitachi C 10FCH2 does not make accurate miter cuts?
- B
  bwardAug 18, 2025
  If your Hitachi Saw does not make accurate miter cuts, consider these potential causes: * The saw blade might be damaged, so replace it. * The positive stop may not be adjusted correctly; check and adjust it. * The workpiece might be moving; clamp it securely to the fence.

Hitachi C 10FCH2 Specifications

General

Input power	1520 W
Power source	AC
Blade bore	30 mm
Blade diameter	255 mm
Idle speed (max)	5000 RPM
Sound power level	95 dB
Bevel setting (left)	45 °
Miter setting (left)	52 °
Sound pressure level	108 dB
Cutting capacity 45° miter	40 x 102 mm