Hitachi C 10FSB

--- 68 ---
a Excessively fast
cutting speed
b Core diameter of
extension cord is too
small.
c Excessive cutting force
is applied due to dull
saw blade.
d Incorrect saw blade is
used.
e The saw blade binds
in workpiece during
cutting because
workpiece is warped
or bent.
a Power cord is not
connected to power
supply.
b Carbon brush wear
exceeds allowable
limit (6 mm).
c Contact failure of the
switch
d Controller failure
a Power supply voltage
is lower than rated
voltage.
b Controller failure
------
------
------
------
------
------
------
------
------
------
• Reduce cutting speed.
• Use a thicker and shorter
extension cord.
• Resharpen saw blade.
• Use a suitable Hitachi-supplied
saw blade.
• An increased number of teeth
on the saw blade increases the
cutting resistance. When using
a saw blade with a large
number of teeth, reduce the
cutting speed.
• Correct workpiece deformation
with planer.
• Check power supply voltage.
• Connect the power cord to
power supply.
• Check the Carbon Brushes
[180] for wear.
• Replace the Carbon Brushes
[180].
• Check the Switch [170] for
conductivity.
• Replace the Switch [170].
• Replace the Controller [151].
• Check that the Controller [151]
is mounted properly.
• Check for power supply
voltage.
• Check if extension cord is
appropriate. See Instruction
Manual for appropriate
extension cords.
• Replace the Controller [151].
Item
Phenomenon
Cause (s)
Factory
standard
Inspection, repair or adjustment
------
3
Saw blade is locked.
4
Saw blade does not
rotate when switch is
triggered.
5
Saw blade runs too slow
(3,400 min
-1
or less).