Table 7-29 Details of the LPAR manager System Service State Screen
No. Item Description
Default
Value
Supported
LPAR
manager
Version
(1) SVP Access Displays the SerVice Processor (SVP)
access status.
RUN: The service is operating normally.
STOP: The service is stopping.
ERROR: The service is in the error state.
UNKNOWN: No updates from the service
patrol.
STOP 01-0X~
(2) BSM
Access
Displays the ServerConductor/Blade Server
Manager (BSM) access status.
RUN: The service is operating normally.
STOP: The service is stopping.
ERROR: The service is in the error state.
UNKNOWN: No updates from the service
patrol.
STOP 01-0X~
(3) HA Monitor Displays the HA Monitor status.
RUN: The service is operating normally.
STOP: The service is stopping.
ERROR: The service is in the error state.
UNKNOWN: No updates from the service
patrol.
STOP 01-0X~
(4) NTP Displays the NTP status.
SYNC: Succeeded synchronization with NTP
NO SYNC: Not synchronized with NTP
ERROR: Failed synchronization with NTP
INACTIVE: Terminated synchronization
with NTP
When multiple NTP servers are configured
and LPAR manager can synchronize the
time with any of the NTP servers, "SYNC" is
displayed on the NTP status. When LPAR
manager cannot synchronize the time with
any of NTP servers, "ERROR" is displayed
on the NTP status.
If a time difference is to be corrected by
NTP time synchronization that is supported
by LPAR manager firmware version 01-60
or later and takes place at a regular
interval of 15 minutes, and if a time
difference of more than 60 seconds occurs,
any subsequent attempts to perform the
NTP time synchronization will be canceled.
If this phenomenon occurs, review the
LPAR manager system log message that
NO SYNC 01-0X~
7-78
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
