Message Content
Save Configuration request(F9 Key) is already accepted.
Please wait.
Explanation The Save configuration request has already been accepted. Wait a
moment.
LPAR manager
operation
Aborts the specified process.
What to do Wait until the configuration begins to be saved.
Message Content
Select Device is Single Port NIC. Can not change
Management Path.
Explanation The NIC you selected in the management path setting is 1 port.
LPAR manager
operation
Aborts the specified process.
What to do Reconsider the specified process.
Message Content Service Ratio must be 1-999
Explanation The service ratio you tried to set was not in the range from 1 to
999 so it could not be set.
LPAR manager
operation
Aborts the service ratio setting.
What to do Set a service ratio between 1 and 999.
Message Content Specified user is not registered.
Explanation The specified user is not registered.
LPAR manager
operation
Aborts the specified process.
What to do Check the user name, and then retry the process.
Message Content Specified user is reserved.
Explanation The specified user name is reserved by LPAR manager.
LPAR manager
operation
Aborts the specified process.
What to do Use another user name to retry user registration.
Message Content Target Device is in invalid type
Explanation This operation is invalid in the target device.
LPAR manager
operation
Aborts the specified process.
What to do Reconsider the specified process.
9-22
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
