2-8 Preparations
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
(2)Connect to the 10G DCB switch module.
Connect to the 10G DCB switch module for the operation on 10G DCB switch
module with the procedure of each Compute Blade Server as followings.
The user ID and the password of 10G DCB switch modules shipped from the
factory are set as below. Please use these information, if needed.
Compute Blade 2000
Compute Blade 500
(0)$ change console -s 0 –F
↑ Enter slot number (0,1,2 or 3.See Note1)
Welcome to the Brocade Network Operating System Software
ssouser$ connected from 127.0.0.1 using console on sw0
sw0#
<< System Console Main Menu >>
P. Start OS console session.
SW. Start switch module console session.
S. System command mode.
X. Exit.
(P,SW,S,X) : SW Enter SW
Select switch module (0-5,[Q=Quit]) : 5 Enter slot number
Confirm? (Y,[N]) : Y Enter Y
Network OS (VDX6746)
NOS Version x.x.x_xxx
sw0 login: admin Enter User ID of administrator (admin).
Password: xxxxx Enter Password
WARNING: The default password of 'admin' and 'user' accounts have not
been changed.
Welcome to the Brocade Network Operating System Software
admin connected from 127.0.0.1 using console on VDX6746
sw0#
To Next Page
Loading...
