Hitachi Compute Blade 320 - Page 69

Utility 6-25
○Boot commands
・EnableBootCode
Description: Switches between "Enable" and "Disable" of the adapter's boot code.
Syntax: hbacmd EnableBootCode <WWPN> <Flag>
Parameter: Flag - E=Enable, D=Disable
・GetBootParams
Description: Displays the boot parameters.
Syntax: hbacmd GetBootParams <WWPN> <Type>
Parameter: Type - X86, EFI, OB
・SetBootParam
Description: Sets the boot parameters.
Syntax: hbaCmd SetBootParam <WWPN> <Type> <Param> <Value1> [BootDev <Value2>]
Parameter: Type - X86, EFI, OB
Param - Parameter name
Value1 - Parameter value
Value2 - Boot entry device No. ｛ 0-7 ｝
○Driver Parameter commands
・GetDriverParams
Description: Displays the names and values of driver parameters.
Syntax: hbacmd GetDriverParams <WWPN>
・GetDriverParamsGlobal
Description: Displays the names and values of driver parameters (Global).
Syntax: hbacmd GetDriverParamsGlobal <WWPN>
・SaveConfig
Description: Saves the driver parameter settings into a file.
Syntax: hbacmd SaveConfig <WWPN> <FileName> <Flag>
Parameter: Flag - G=Global, N=Non-Global(adapter-specific)
・SetDriverParam
Description: Changes driver parameters.
Syntax: hbacmd SetDriverParam <WWPN> <Flag1> <Flag2> <Param> <Value>
Parameter: Flag1 - L=Only the specified adapter is targeted (Local), G=All adapters are targeted (Global)
Flag2 - P=Permanent change (Permanent: Effective even after reboot), T=Temporary change (Temporary)
Param - Parameter name
Value - Parameter value
・SetDriverParamDefaults
Description: Resets all driver parameters to their default values.
Syntax: hbacmd SetDriverParamDefaults <WWPN> <Flag1> <Flag2>
Parameter: Flag1 - L=Only the specified adapter is targeted (Local), G=All adapters are targeted (Global)
Flag2 - P=Permanent change (Permanent: Effective even after reboot), T=Temporary change (Temporary)
When driver parameter is set persistently and/or requires a reboot, the ramdisk must be rebuilt. To build
the ramdisk, type: # /usr/src/lpfc-install --createramdisk
# reboot
!
Note