6-26 Utility
○Dump commands
・DeleteDumpFiles
Description: Deletes all dump files of the adapter.
Syntax: hbacmd DeleteDumpFiles <WWPN>
・Dump
Description: Creates a dump file for diagnosis.
Syntax: hbacmd dump <WWPN>
・GetDumpDirectory
Description: Displays the creation destination directory of a dump file for diagnosis.
Syntax: hbacmd GetDumpDirectory <WWPN>
・GetRetentionCount
Description: Displays the number of retained dump files.
Syntax: hbacmd GetRetentionCount <WWPN>
・SetRetentionCount
Description: Sets the maximum number of retained dump files.
Syntax: hbacmd SetRetentionCount <WWPN> <Value>
○WWN Management commands
WWN Management validates WWNs very carefully to avoid name duplication. A reboot is required to
activate the new setting.
This adapter does not support a volatile change.
・ChangeWWN
Description: Changes WWN (WWPN and WWNN).
Syntax: hbacmd ChangeWWN <WWPN> <New WWPN> <New WWNN> <Type>
Parameter: Type - 0=Volatile, 1=Non-Volatile
・ReadWWN
Description: Displays WWN (WWPN and WWNN).
Syntax: hbacmd readWWN <WWPN> <Type>
Parameter: Type - 0=Volatile, 1=Non-Volatile, 2=Factory Default, 3=Current, 4=Configured
・RestoreWWN
Description: Changes WWN to the factory default or the non-volatile value.
Syntax: hbacmd RestoreWWN <WWPN> <Type>
Parameter: Type - 0=Default WWNs, 1=NVRAM WWNs (Non-Volatile)
!
Note
To Next Page
Loading...
