46
SETUP menu
(continued on next page)
Item Description
LAMP &
FILTER
AUTO ECO
MODE
Using the ▲/▼ buttons turns on/off the AUTO ECO MODE.
ON
ó
OFF
• When ON is selected, the projector will always be set to Eco-
2 mode at start-up regardless of the ECO MODE (
46) set-
ting. An OSD message “AUTO ECO MODE” will be displayed
for tens of seconds when the projector starts with this function
activated.
ECO MODE
Using the ▲/▼ buttons switches the ECO MODE.
OFF
ó
ECO-1
ó
ECO-2<=>INTELLIGENT ECO
ó
SAVER
• When the ECO-1/2 is selected, acoustic noise and screen
brightness are reduced.
• When INTELLIGENT ECO is selected, the brightness of the
lamp changes according to the level of the input signal. The
lamp becomes brighter when the input signal level is high
and darker when the level is low. If dark images are projected
continuously, the brightness of the lamp may increase to
maintain its performance.
• When SAVER is selected, you can select the time within 1
to 30 min. for SAVER MODE using the ► button. If the image
signal level doesn’t change more than the period set, the
lamp brightness is reduced and electric power consumption
decreased. If the image signal level changes or any buttons
are operated, the lamp will brighten again. If dark images are
projected continuously, the brightness of the lamp may increase
to maintain its performance.
• When AUTO ECO MODE (
above) is set to ON, the projector
will always be set to Eco-2 mode at start-up regardless this
setting.
• When the ambient temperature is around 35 to 40°C, the
brightness of lamp is reduced automatically.
To Next Page
Loading...
