42
OPTION menu
OPTION menu
From the OPTION menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons,
and press the ► cursor (or the ENTER) button to
execute the item, except for the items LAMP TIME
and FILTER TIME. Then perform it according to the
following table.
Item Description
AUTO SEARCH
Using the ▲/▼ cursor buttons turns on/off the automatic signal
search function.
ON
OFF
When the ON is selected, detecting no signal automatically cycles
through input ports in the following order. The search is started from
the current port. Then when an input is found, the projector will stop
searching and display the image.
COMPUTER IN1
COMPUTER IN2
VIDEO
S-VIDEO
DIRECT
POWER ON
Using the ▲/▼ cursor buttons turns on/off the
DIRECT POWER
ON
function.
ON
OFF
When set to the ON, the lamp in projector will be automatically
turned on without the usual procedure (
14), only when the
projector is supplied with the power after the power was cut while
the lamp was on.
• This function does not work as long as the power has been
supplied to the projector while the lamp is off.
•
After turning the lamp on by the DIRECT POWER ON function,
if neither input nor operation is detected for about 30 minutes, the
projector is turned off, even though the
AUTO POWER OFF function
(
43) is disabled.
(continued on next page)
To Next Page
Loading...
Need help?
General
