45
Item Description
STANDBY MODE
Using ▲/▼ buttons switches the standby mode setting between
NORMAL and SAVING.
NORMAL
ó
SAVING
When SAVING is selected, the power consumption in the standby
mode is lowered with some functional restriction as below:
• The RS-232C communication control is disabled except turning
the projector on and changing the STANDBY MODE setting.
• When SAVING is selected, STANDBY setting of AUDIO SOURCE
(
46) is invalid, no signal is output from AUDIO OUT port and no
sound from a built-in speaker.
• When SAVING is selected, STANDBY setting of MONITOR OUT
is invalid, and no signal is output from MONITOR OUT port in the
standby mode.
MONITOR OUT
While the image signal from the input port chosen in step (1) is
projected, the image signal from the input port selected in step (2) is
output to MONITOR OUT port.
(1) Choose a picture input port using ▲/▼ buttons.
Choose STANDBY to select the picture
output in the standby mode.
(2) By using ◄/► buttons, select
COMPUTER IN 1 port or OFF to disable
the MONITOR OUT port for the input port
or standby mode chosen in the step (1).
• If you have changed the setting of STANDBY, it applies only to
the current standby mode, NORMAL or SAVING, selected under
STANDBY MODE, without changing the setting of the other mode.
The factory settings are as follows:
- COMPUTER IN1 for the NORMAL mode of STANDBY MODE
- OFF for the SAVING mode of STANDBY MODE
• It is invalid if MONITOR OUT is not selected under COMPUTER
IN 2.
SETUP menu
To Next Page
Loading...
