31
CP-SX1350(P5SX+)
7. Wiring diagram
CNPWR
1. Wiring of the electrical board block
(1) Wiring of the electrical board
(for assembling the electrical board sub assembly).
Pass the three kinds of cables through
the notch in the power board holder,
and take up any slack.
(The resulting slack may come into
contact with the primary side of the
power board.)
TSW
CNPW1
CNPW2
Connect the CNPW1, CNPW2 and TSW
cables to the respective connectors for the
CN102, CN103, and CN104 circuit power
boards, and verify that they are properly
connected.
Be careful not to pull on the cables too much
when reducing slack so as not to compromise
the connectors.
CNPW1
CNPW2
TSW
CN102
CN103
CN104
Be careful not to lift the
connectors in the three spots
as depicted in the illustration
at left.
The connections have become
compromised.
Example of compromised
connections
(2) Wiring of the ballast board (for assembling the ballast board sub assembly).
Lamp
leads
CNBAR
Pass the CNBAR cable through the notch
in the ballast holder.
Connect the CNBAR cable to the ballast board's CN2 connectors,
and make sure that they are well connected.
CN101
CN1
CN2
CN104
CN103
CN102
Connect the CNPWR cable to the circuit
power board's CN101 connector, make
sure that the connector lock is snug.
Attach FEB1 to the CNPWR cable.
SK binder does not need to be used.
Get close to the circuit power board's
CN101 connector.
FEB1
Wiring diagram 1
To Next Page
Loading...
