64
SECURITY menu
Item Description
TRANSITION
DETECTOR
If this function is set to ON when the vertical angle of
the projector or mirror setting at which the projector is
turned on is different than the previously recorded, the
TRANSITION DETECTOR ON alarm will be displayed
and the projector will not display the input signal.
•
To display the signal again, set this function OFF.
•
After about 5 minutes of displaying the TRANSITION DETECTOR ON alarm,
the lamp will turn off.
• Keystone adjustment feature has been prohibited as long as the Transition
Detector function is on.
1 Turning on the TRANSITION DETECTOR
1-1 Use the ▲/▼ buttons on the SECURITY menu to
select TRANSITION DETECTOR and press the ►
or the
ENTER button to display the TRANSITION
DETECTOR on/off menu. Select ON and the
current angle and mirror setting will be recorded.
1-2 Use the ▲/▼ buttons on the SECURITY menu to select Transition
Detector and press the ► or the
ENTER button to display the Transition
Detector on/off menu.
1-3 Use the ▲/▼ buttons on the TRANSITION
DETECTOR on/off menu to select ON. The
ENTER PASSWORD box (small) will be
displayed.
1-4
Use the
▲/▼/◄/►
buttons to enter a password.
Move the cursor to the right side of the ENTER
PASSWORD box (small) and press the
►
button
to display the PASSWORD AGAIN box, enter the
same password again.
1-5 Move the cursor to the right side of the
PASSWORD AGAIN box and press the ►
button to display the NOTE PASSWORD box
for about 20 seconds, please make note of the
password during this time.
• Pressing the
ENTER button on the remote control or the
VIDEO button
on the projector will return to the TRANSITION DETECTOR on/off menu.
• Please do not forget your TRANSITION DETECTOR password.
• This function will activate only when the projector is started after the power
switch was turned off.
•
This feature may not function properly if the projector
is not in a stable position
when ON is selected.
2 Turning off the TRANSITION DETECTOR
2-1
Follow the procedure in 1-1 to display the Transition Detector on/off menu.
2-2 Select OFF to display the ENTER PASSWORD box (large). Enter the
registered password and the screen will return to the TRANSITION
DETECTOR on/off menu.
If an incorrect password is input, the menu will close. If necessary, repeat
the process from 3-1.
3 If you have forgotten your password
3-1
Follow the procedure in 1-1 to display the Transition Detector on/off menu.
3-2
Select OFF to display the ENTER PASSWORD box
(large). The 10 digit Inquiring Code will be displayed
inside the box.
3-3 Contact your dealer with the 10 digit Inquiring
Code. Your password will be sent after your
user registration information is confi rmed.
(continued on next page)
ENTER PASSWORD box
(small)
ENTER PASSWORD box (large)
To Next Page
Loading...
