52
OPTION menu
Item Description
SERVICE
(continued)
REMOTE ID
Use the ▲/▼ buttons on the REMOTE ID menu to select ID and
press the ► button
.
ALL
1
2
3
4
The projector is controlled by the remote control whose ID button is
set the same number as this number. When the ALL is selected, the
projector is controlled by a remote control irrespective of the ID setting.
COMMUNICATION
Selecting this item displays COMMUNICATION menu.
In this menu, you can confi gure the communication settings
of the
CONTROL OUT
ports.
• Select an item using the cursor buttons
▲/▼
. Then
pressing the ► button opens the submenu for the
setting item you selected.Or, pressing the ◄ button
instead of the ► button makes the menu back to the
previous one without changing the setup.
Each submenu can be operated as described above.
COMMUNICATION TYPE
In this menu, you can select
the communication type for
transmission from the
OUT port.
NETWORK BRIDGE
DAISY CHAIN
OFF
NETWORK BRIDGE: Select this type, if it is required
to control an external devise as a network terminal, via
this projector from the computer. (
Network Guide -
3.7 Controlling the external equipment via the projector
(using the NETWORK BRIDGE function))
• The selectable items on the
COMMUNICATION menu are varied according to
the setup of the COMMUNICATION TYPE.
• For the function of serial communication, refer to
the Network Guide (
Network Guide - 3.7, 3.8).
NOTE
COMMUNICATION TYPE
SERIAL IN SETTING
COMMUNICATION ID SERIAL OUT SETTING
COMMUNICATION GROUP TRANSMISSION METHOD
BYTES INTERVAL TIMEOUT
RESPONSE LIMIT TIME
To Next Page
Loading...
