OPTION menu
From the OPTION menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor
button on the projector or remote control, or
ENTER
button on the remote control to execute the item,
except for the items LAMP TIME and FILTER TIME.
Then perform it according to the following table.
Item Description
SOURCE SKIP
The port that is set to the "SKIP" is ignored in searching by the AUTO
SEARCH function
(
below )
or the buttons of COMPUTER, VIDEO, or
DIGITAL
(
22 )
.
(1) Choose a picture input port using ▲/▼ buttons.
(2) Using the ◄/► buttons turns on/off the SOURCE SKIP function.
NORMAL
SKIP
•
This setting of "SKIP" is not available when specifying one certain input
port by MY SOURCE button etc.
AUTO SEARCH
Using the ▲/▼ buttons turns on/off the automatic signal search function.
ON
OFF
When the ON is selected, detecting no signal automatically cycles through
input ports in the following order. The search is started from the current
port. Then when an input is found, the projector will stop searching and
display the image.
COMPUTER IN1
COMPUTER IN2
BNC
HDMI
DVI-D
VIDEO 2
VIDEO 1
S-VIDEO
COMPONENT
• The port that is set to the "SKIP" is ignored in searching by the
AUTO SEARCH function (
above ).
AUT
O
KEYSTONE
Using the ▲/▼ buttons turns on/off the automatic keystone function.
ON
OFF
ON : Automatic keystone distortion correction will be executed
whenever changing the slant of the projector.
OFF : This function is disabled. Please execute the AUTO
KEYSTONE in the SETUP menu for automatic keystone distortion
correction.
• When the projector is suspended from the ceiling this feature will
not function properly so select the OFF.
• This function will be unavailable when the Transition Detector is
on
(
22 )
.
(continued on next page)
To Next Page
Loading...
