ENTER button on the remote control to execute the item.
FAN SPEED
Using the ▲/▼ buttons switches the rotation
speed of the cooling fans. The HIGH is the
mode for use at highlands etc. Note that the
projector is noisier when the HIGH is selected.
HIGH
NORMAL
AUTO ADJUST
Using the ▲/▼ buttons to select one of the mode.
When the DISABLE is selected, the automatic
adjustment feature is disabled.
FINE
FAST
DISABLE
FINE: Finer tuning including H.SIZE adjustment.
FAST:
Faster tuning, setting H.SIZE to prearranged data for the input signal.
•
Depending on conditions, such as input image, signal cable to the projector,
environment around the projector, etc., the automatic adjustment may not
work correctly. In such a case, please choose DISABLE to disable the
automatic adjustment, and make adjustment manually.
GHOST
1.
Select a color element of ghost using the
◄/►
buttons.
2.
Adjust the selected element using the ▲/▼
buttons to disappear ghost.
FILTER MESSAGE
Use the ▲/▼ button to set the timer for notifying
by the message when to replace the fi lter unit
2000h
5000h
10000h
OFF
After choosing an item except OFF, the message
“REMINDER *** HRS PASSED AFTER THE LAST FILTER
CHANGE” will appear after the timer reaches the interval time
set by this feature
(
71 )
.
When the OFF is chosen, the message will not appear.
Utilize this feature to keep the air fi lter clean, setting the suitable time according
to your environment of this projector.
Refer to the following criterion.
2000h: recommended for use in an indoor environment in a so
dusty area, such as a desert or an area in which yellow sands float.
5000h: recommended for use in an indoor environment, such as a
place by a window, near a passage.
10000h: recommended for use in a general indoor environment.
• Please take care of the fi lter unit periodically, even if there is
no message. If the air fi lter becomes to be blocked by dust or
other matter, the internal temperature will rise, which could cause
malfunction, or reduce the lifetime of the projector.
•
Please be careful with the operating environment of the projector
and the condition of the fi lter unit.
(continued on next page)
To Next Page
Loading...
