112
• When the interior portion has become overheated, for safety
purposes, the projector is automatically shut down, and the indicator lamps
may also be turned off. In such a case, disconnect the power cord, and wait at
least 45 minutes. After the projector has sufficiently cooled down, please make
confirmation of the attachment state of the lamp and lamp cover, and then turn
the power on again.
If the projector is used at an altitude of about 1600 m (5250 feet)
or higher, set ALTITUDE of the SERVICE item in the OPTION menu to HIGH (
60).
Otherwise, set it to NORMAL.
NOTE
Troubleshooting
POWER
indicator
LAMP
indicator
TEMP
indicator
Description
Blinking In
Green for
approx. 3
seconds.
Turned
off
Turned
off
At least 1 Power ON schedule is saved to the
projector.
Please refer to Schedule Settings in the Network
Guide.
Lighting
In
Orange
Lighting
In
Red
Lighting
In
Red
Loading the saved data of CLONING on STANDBY
MODE.
Blinking
In
Orange
Blinking
In
Red
Blinking
In
Red
Loading the saved data of CLONING has failed on
STANDBY MODE.
Please refer to CLONING (
64 ~ 66).
Turned
off
Turned
off
Turned
off
Loading the saved data of CLONING has succeeded
on STANDBY MODE.
Regarding the indicator lamps (continued)
To Next Page
Loading...
