Hitachi CP-WX410 - Searching an Input Signal; Selecting an Aspect Ratio

17
1.
Press ASPECT button on the remote control.
Each time you press the button, the projector switches the mode
for aspect ratio in turn.
Selecting an aspect ratio
● ASPECT button does not work when no proper signal is inputted.
● NORMAL mode keeps the original aspect ratio setting.
1.
Press SEARCH button on the remote control.
The projector will start to check its input ports as below in order to
nd any input signals.
When an input is found, the projector will stop searching and
display the image. If no signal is found, the projector will return to
the state selected before the operation.
Searching an input signal
● While TURN ON is selected for AUTO SEARCH item in OPTION menu (41), the
projector will keep checking the ports in above order repeatedly till an input signal is
detected.
 For a computer signal
NORMAL  4:3  16:9  16:10  REAL
 For a video signal, s-video signal or component video
signal
4:3  16:9  16:10 14:9  REAL
 For no signal
16:10 (xed)
SEARCH button
ASPECT button
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT SEARCH
BLANK
MUTE
MY BUTTON
POSITION
12
ESC
ENTER
MENU
RESET
COMPUTER
MY SOURCE/
AUTO
MAGNIFY
PAGE
UP
VOLUME
DOWN
࡯
ON
OFF
㧗
FREEZE
VIDEO
DOC.CAMERA
KEYSTONE
ASPECT SEARCH
BLANK
MUTE
MY BUTTON
POSITION
12
ESC
ENTER
MENU
RESET
COMPUTER
MY SOURCE/
AUTO
MAGNIFY
PAGE
UP
VOLUME
DOWN
࡯
ON
OFF
㧗
FREEZE
Operating
 For an HDMI signal
NORMAL  4:3  16:9  16:10  14:9  REAL
COMPUTER IN 1  COMPUTER IN 2  HDMI
VIDEO

S-VIDEO

COMPONENT (Y, Cb/Pb, Cr/Pr)