Introduction
Part names
(1) Lamp cover (93)
The lamp unit is inside.
(2) FOCUS ring (24)
(3) ZOOM ring (24)
(4) Control panel (5)
(5) Elevator buttons (x 2) (24)
(6) Elevator feet (x 2) (24)
(7) Remote sensor (17)
(8) Lens (97)
(9) Intake vents
(10) Filter cover (95)
The air lter and intake vent are
inside.
(11) Speaker (46)
(12) Exhaust vent
(13) AC IN (AC inlet) (15)
(14) Rear panel (5)
(15) Security bar (16)
(16) Security slot (16)
HOT!
HOT!
(12)
(1)
(2) (3) (4)
(7)
(9)
(8)
(10)
(6)
(5)
(11)
(6)
(15)
(13)
(16)
(14)
(5)
(9)
►Do not open or remove any portion of the product, unless the
manuals direct it.
►Do not subject the projector to unstable conditions.
►Do not apply a shock or pressure to this product.
►Do not look into the lens and the openings on the projector while the lamp is
on.
WARNING
►Do not touch around the lamp cover and the exhaust
vents during use or just after use, since it is too hot.
►Do not attach anything onto the lens except the lens cover of this
projector because it could damage the lens, such as melting the lens.
CAUTION
(continued on next page)
To Next Page
Loading...
Need help?
General
