6
Angle Adjustment
1
Lift up the front side of the
projector, and pressing the foot
adjuster button, adjust the
projection angle.
2
Release the button to lock at the desired angle.
3
Turn the rear foot adjuster to adjust
the left-right slope. Do not force the
foot adjuster screws. This could
damage the adjusters or cause the
lock to fail.
Use the foot adjusters on the bottom of the projector to adjust the projection
angle. It is variable within 0˚ to 9˚ approximately.
CAUTION •
Install the projector in a suitable environment according to instructions
of the accompanying manual “SAFETY INSTRUCTIONS” and this manual.
• If you press the elevator buttons without holding the projector, the projector might
crash down, overturn, smash your fingers and possibly result in malfunction. To
prevent damaging the projector and injuring yourself, ALWAYS HOLD THE
PROJECTOR whenever using the elevator buttons to adjust the elevator feet.
SETTING UP THE PROJECTOR
Press the foot adjuster button
Rear Foot Adjuster
01CPX385/EN最終02.11.74:15PMページ6
To Next Page
Loading...
Need help?
General