11
1.4 Selecting the network connection mode (continued)
• If you click the [Yes], the network access by the “LiveViewer” is
temporally permitted by Windows rewall, until the “LiveViewer” is closed.
• If any application software having the rewall function is installed into you
computer, make the rewall function invalid with following the user’s manual.
NOTE
A network connection was not established.
The screen is displayed in the case that the
projector is not connected with a LAN cable
to your computer when the wired LAN is
selected.
Be sure that the projector is connected with
a LAN cable to your computer.
Click the [OK], then the screen is back to the previous one to select the network
connection mode.
Windows rewall is enabled (On).
The screen is displayed in the case that
the rewall setting is activated, and the
“LiveViewer” is blocked by the rewall.
• To turn it disabled (Off), click the [Yes].
• Not to turn it disabled (Off), click the
[No], but the projector may not be able to
communicate with your computer through
the network.
Proceed to item 1.5 Selecting the network connection method. (
14)
• If you put a check mark in the [Allow communication with LiveViewer by
adding it to the Exceptions list] box, the “LiveViewer” will never be blocked
by Windows rewall.
1. Connection to the network
To Next Page
Loading...
