33
1.9 Profile data
The network setting to connect the projector and computer can be stored as a
prole data. Once the data is stored, all you need to do is to select the data to
connect to the network. It is recommended when the same network connection is
often used.
1.9.1 Outline of Profile data
The prole data is made on the Manual
Conguration screen. (
23)
Up to 10 prole data can be stored for each
network adapter.
1) Select
the
[Prole] and click
the
[New].
2) The “Create new prole” will come up.
If you have already made 10 prole data,
you cannot make a new one, until you delete
a stored data.
Input all information required for your
network connection.
If you want to clear the information you input,
click
the
[Clear].
1.9.2 Making Profile data
3) Click
the
[OK], after all information is set.
If you don’t want to store it, click
the
[Cancel].
4) The new prole data is shown in the prole list, if you click
the
[OK].
• When you make a new prole data, it is strongly recommended to
check that the new dada can work properly by selecting the data at the Prole
connection. (23)
• If you change a network adapter on your computer, make a new prole data
for the adapter.
NOTE
1. Connection to the network
To Next Page
Loading...
