14
Setting up
Speakers
(with an amplier)
Wired
remote
control
(optional)
Monitor
Microphone
system
Connecting with your devices (continued)
• If a loud feedback noise is produced from the speaker, move the
microphone away from the speaker.
• This projector doesn't support plug-in power for the microphone.
NOTE
•
You can connect a dynamic microphone to the MIC port with a 3.5 mm mini-plug.
In that case, the built-in speaker outputs the sound from the microphone, even
while the sound from the projector is output. You can input line level signal to
the MIC port from equipment such as wireless microphone. Select HIGH in the
MIC LEVEL item of the AUDIO menu when you input line level audio signal
to the MIC port. In the normal mode, the volume of the microphone can be
adjusted separately from the volume of the projector using the menu. (46, 47)
In the standby mode, the volume of the microphone is adjustable with the
VOLUME +/- buttons on the remote control, in synchronization with the volume
of the projector. (19)
Even when the sound of projector is set to mute mode by the AUDIO SOURCE
function (
46), the volume of the microphone is adjustable.
In both modes (standby or normal), the MUTE button on the remote control
works on the sounds of the microphone and the projector. (19)
• This projector doesn't support plug-in power for the microphone.
Microphone function
(46)
(45)
To Next Page
Loading...
