23
Operating
Using the menu function
This projector has the following menus: PICTURE, IMAGE, INPUT, SETUP, AUDIO,
SCREEN, OPTION, NETWORK, and EASY MENU. EASY MENU consists of functions
often used, and the other menus are classied into each purpose. Each of these menus is
operated using the same methods. The basic operations of these menus are as follows.
1.
Press the MENU button on the remote control or one of
the cursor buttons on the projector.
The Advanced MENU, or EASY MENU that has priority just
after powered on, will appear.
In the EASY MENU
2.
If you want to change it to the Advanced MENU, select the
"Go to Advanced Menu..."
3.
Use the cursor buttons ▲/▼ to select an item to operate.
4.
Use the cursor buttons◄/► to operate the item.
In the Advanced MENU
2.
Use the cursor buttons ▲/▼ to select a menu.
If you want to change it to the EASY MENU, select the
EASY MENU.
Then press the cursor button ► on the projector or remote
control, or the ENTER button on the remote control to select
an item. The display of the selected menu will be active.
3.
Use the cursor buttons ▲/▼ to select an item to operate.
Then press the cursor button
►
on the projector or remote control, or the ENTER button
on the remote control to progress. The operation menu of the selected item will appear.
4.
Use the cursor buttons▲/▼ to operate the item.
●
When you want to reset the operation, press the RESET button on the remote control
during the operation. Note that items whose functions are performed simultaneously
with operation (ex. LANGUAGE, H PHASE, VOLUME etc.) cannot be reset.
●
In the Advanced MENU, when you want to return to the previous display, press the
cursor button
◄
on the projector or remote control, or the ESC button on the remote
control.
5.
Press the MENU button on the remote control again to close the menu
and complete this operation. Even if you do not do anything, the dialog will
automatically disappear after about 10 seconds.
● Some functions cannot be performed when a certain input port is selected, or
when a certain input signal is displayed.
To Next Page
Loading...
Need help?
General
