Selecting an input signal
1.
Press the INPUT/ENTER button on the projector.
Each time you press the button, the projector switches
its input port as below.
COMPUTER IN1
COMPUTER IN2
VIDEO
S-VIDEO
USB STORAGE
Operating
Operating
Adjusting the volume
1.
Press the VOLUME button on the remote control.
A dialog will appear on the screen to aid you in adjusting the
volume.
2.
Use the ▲/▼ cursor buttons to adjust the volume.
To close the dialog and complete the operation, press the
VOLUME button again. Even if you do not do anything, the dialog
will automatically disappear after a few seconds.
● When
is selected for the AUDIO item of the SETUP menu
(
32), the volume adjustment is disable
.
Temporarily muting the sound
1.
Press the MUTE button on the remote control.
A dialog will appear on the screen indicating that you have muted the sound.
To restore the sound, press the MUTE or VOLUME button. Even
if you do not do anything, the dialog will automatically disappear
after a few seconds.
● When
is selected for the AUDIO item of the SETUP menu
(
32), the volume adjustment is disable
.
1.
Press the COMPUTER/STORAGE button on the
projector.
Each time you press the button, the projector switches
its input port as below.
COMPUTER IN1
COMPUTER IN2
USB STORAGE
● If the COMPUTER/STORAGE button is pushed to switch from
a signal from the VIDEO or S-VIDEO port, when TURN ON is
selected for the AUTO SEARCH item in the OPTION menu
(
37)
,
the projector will check the COMPUTER IN1 port rst. If no input is
detected at the port, the projector will check other port in above order.
● Selecting the USB STORAGE port displays the THUMBNAIL menu. For more
information, please see the “USB STORAGE”
(
49)
.
(continued on next page)
INPUT/ENTER
To Next Page
Loading...
