Enable Hi-Track Remote Monitoring System
Hi-Track provides the remote monitoring and support functionality for Hitachi products. Hitachi
recommends you install and congure Hi-Track to monitor the storage system at the customer site.
For more information, download the Hi-Track documentation from the Hitachi Data Systems Support Portal:
https://portal.hds.com/
7
Complete System Setup
Serial number locaon
7
6
3. Register your storage system
1. In a browser, type https://portal.hds.com.
2. Under Login, click Need to register?
3. Follow the on-screen instructions. When nished, log out of the Portal.
4. Log in to the Portal using the email address and the password sent by email.
5. Click My Products.
6. Conrm that your storage system appears under My Products. If not, click Register Additional Product and follow the
on-screen instructions.
7. At the Conrm Registration page, click Register.
8. Wait 15 minutes, and then click My Products and conrm that your storage system is registered.
Helpful links
Product documentation: https://portal.hds.com
Product interoperability: http://www.hds.com/products/interoperability
HDS Community: https://community.hds.com
Frequently asked questions: https://community.hds.com/groups/vsp-self-service
1. Make host connections
Congure the storage system host settings. Refer to the Hitachi Open-Systems Host Attachment Guide and the HDS Product Interopera-
bility Documentation at http://www.hds.com/products/interoperability.
Follow the instructions in your host, HBA, and NIC vendor documentation for information about host conguration.
Connect the Fibre Channel and iSCSI ports on the storage system to your network switch. Refer to the gures below and to your
switch documentation for details. Ports are color-coded for reference.
2. Record storage system serial number:
Fibre-Channel
cables
Hitachi Data Systems Corporaon 2015.
All rights reserved.
c
FE-94HM8031-00
Hitachi Virtual Storage Plaorm
G200 Quick Start