Hitachi HISCREW 2000 Series - 3.2 How to Use the Digital Monitor and its Controls

8
DRYER
ドライヤー
エコモード
SELECT
警報
SHUTDOWNALARM
RESET
表示切替
10h×
リセット
故障
C：温度 TEMP
RUNNINGCONTROL 運転管理
ECOMODE
Ｅ：故障コード ERRORCODE
OperatingHours(×10h)
Dot:Indicatesupdatingoftheoperatinghours.
P:PressureinMPa(Unused.)
C:DischargeairtemperatureinCelsius
L:Loadingrateinpercent
U:Totalloadingtime(×10,000)
E:Alarm/shutdowncode
Holddownformore
than3seconds.
Holddownformore
than7seconds.
Holddownformore
than3seconds.
Holddownformore
than3seconds.
Pressto
return.
SELECT
表示切替
SELECT
表示切替
Pressforeachnewscreen.
SELECT
表示切替
Press
SELECT
表示切替
SELECT
表示切替
SELECT
表示切替
RESET
リセット
押す
(Availableonlywhenanalarm/shutdown
problemhashappened.)
DigitalMonitor
Newestshutdown
Secondnewest
shutdown
Oldestshutdown
XX:Shutdowncode
Nottobeused
bytheusers.
F3andthefurthernumbers
3.2 How to Use the Digital Monitor and its Controls
(1) Displaying the Operating Hours, Pressure, Discharge Air Temperature,
Loading Rate, Total Loading Time, and Alarm or Shutdown Code
3. HOW TO OPERATE [How to Use Digital Monitor and its Controls]
When you connect the power, the digital monitor displays the
total operating hours. To display other data, do as follows:
q Press the SELECT button. The screen displays “P0.00.”
This screen is unused.
w Press the SELECT button. The screen displays “C”
together with the discharge air temperature.
e Press the SELECT button. The screen displays “L”
together with the loading rate. The system flushes
figures when in calculation.
r Press the SELECT button. The screen displays “U”
together with the total loading time (× 10,000).
Refer to the IMPORTANT.
t Press the SELECT button. When the alarm/shutdown
light is:
・ on (flashing), the screen displays “E” (flashing)
together with the alarm/shutdown code (
☞
pp.
23-24). Press the SELECT button to return to the
original screen of total operating hours.
・ off, you directly return to the original screen of
total operating hours.
To display other data, do as follows:
q Hold down the SELECT button. The screen displays
“F0” together with the shutdown code (
☞
pp. 23-24).
The “0” indicates the newest shutdown.
w Press the SELECT button. The screen displays “F1”
together with the shutdown code. The “1” indicates the
second newest shutdown.
e Press the SELECT button. The screen displays “F2”
together with the shutdown code. The “2” indicates the
oldest shutdown.
r Press the RESET button. The screen returns to what
you have left with the action q above. If you press the
SELECT button instead, the screen displays “F3” (and
the further numbers) which are not to be used by the
users.
Displaying the “ ” in the action q indicates that no shut-
downs are stored in the memory.
IMPORTANT
(2) Displaying the Shutdown History
If you want to display the exact total loading
time (× 10), hold down the SELECT button
and press the RESET button.
IMPORTANT