Deskstar 7K160 Hard Disk Drive Specification
112
10.22.1.4 Extended Status Code
10.22.1.5 Data transfer
Once an SCT command has been issued, status can be checked and data can be transferred. Data transfer uses log
page E1h.
Status Code Definition
0000h Command complete without error
0001h Invalid Function Code
0002h Input LBA out of range
0003h Request sector count overflow. The number of sectors requested to
transfer (Sector Count register) in the read or write log command is
larger than required by SCT command.
0004h Invalid Function code in Error Recovery command
0005h Invalid Selection code in Error Recovery command
0006h Host read command timer is less than minimum value
0007h Host write command timer is less than minimum value
0008h Background SCT command was aborted because of an interrupting
host command
0009h Background SCT command was terminated because of unrecoverable
error
000Ah Invalid Function code in Long Sector Access command
000Bh SCT data transfer command was issued without first issuing an SCT
command
000Ch Invalid Function code in Feature Control command
000Dh Invalid Feature code in Feature Control command
000Eh Invalid New State value in Feature Control command
000Fh Invalid Option Flags in Feature Control command
0010h Invalid SCT Action code
0011h Invalid Table ID (table not supported)
0012h Command was aborted due to drive security being locked
0013h Invalid revision code
0017h Blocking SCT Segment Access command was terminated because of
unrecoverable error
0018h-BFFFh Reserved
C000h-C002h Vendor Specific
C003h Overlay switch failure in Long Sector Access command
C004h Read Long failure
C005h Write Long failure
C006h Write Cache enable failure
C007h-FFEFh Vendor Specific
FFF0h-FFFEh Reserved
FFFFh SCT command executing in background
To Next Page
Loading...
