Channe|s
Select CHANNELS to set your signal source options, run New
Channel Scan, Check Signal Meter and Set Channel List (Add
channels to List, Channel/Labels and Favorite Channels).
Add Channels to List
This function allows you to add channels to the channel memory.
Sometimes adjusting the antenna direction will allow reception of
additional channels..
1. Press CURSOR PAD A, Y to highlight functions.
2. Press the SELECT button or CURSOR PAD I_ to select.
1. Use the CURSOR PAD to select the Add Channels to List.
2. Press the SELECT button to start scanning.
3. Press the EXIT button to return to normal viewing.
Only the Channels that have not been added to the list will be
stored.
Source
Select the signal Source for the TV. When using an indoor or
outdoor antenna select Air. When using a cable system select
Cable.
Signal Strength
Select Signal Strength when using an indoor or outdoor antenna.
This feature will show the signal strength of the Antenna signal to
help you adjust your antenna to optimize signal reception. Use the
MENU button or EXIT button to return.
The Signal Strength will not be available (grayed
out) when watching analog channels.
New Channel Scan
This feature will automatically store active Analog and Digital
channels to the Channel list. This scan will erase all channels
previously stored in the list.
Channel List
This function allows you to review which channels have been
added to the CHANNEL list.
1. Use the CURSOR PAD to navigate the Channel List.
2. Press the SELECT or _, button to select SKIP or View.
3. Press the EXIT button to return to normal viewing.
The Channel List cannot be updated by only changing the cable
source. Auto Channel Scan must be performed for the Channel
List to be updated.
1.
Use the CURSOR buttons to highlight then press SELECT key
to start.
If you do not want to erase all scanned channels,
please use the Add Channels to List option instead.
33
To Next Page
Loading...
Need help?
General
