Hitachi LP-AW4001 - Connection in Simple Access Point Mode

15
2.1.1 Connection in Simple Access Point Mode
Set the following when connecting the projector and the computer in Simple
Access Point mode.
Projector setting
1) Turn on the projector.
2) Press the MENU button on the remote control
or the control panel of the projector.
The MENU you last used will appear.
Use the cursor button to select the following.
($6<0(18!$'9$1&('0(18!
NETWORK > NETWORK SETUP >
:,5(/(666(783
6HWWKHIROORZLQJLWHPVLQ:,5(/(666(783
02'(6,03/($&&(6632,17
,3$''5(66
66,'
66,'%52$'&$67
(1&5<37,21
6HOHFW$33/<WKHQSUHVVWKHENTEREXWWRQWRUHÀHFWWKHVHWWLQJV
$VIRUWKHSURFHGXUHRIVHWWLQJQHWZRUNDQGZLUHOHVVFRQQHFWLRQIRUWKH
FRPSXWHUUHIHUWRWKHPDQXDORIWKHFRPSXWHURUZLUHOHVV/$1GHYLFH
8SWRGHYLFHVFDQEHFRQQHFWHGWRWKHSURMHFWRULQ6LPSOH$FFHVV3RLQWPRGH
About network settings
䡡㻌7KHIRXUWKRFWHWRIWKHSURMHFWRUV,3DGGUHVVLV¿[HGWR.
䡡㻌6XEQHWPDVNRIWKHSURMHFWRULV¿[HGWR
Computer setting
7KH'+&3VHUYHUIXQFWLRQRIWKHSURMHFWRULVDOZD\VHQDEOHG(QDEOHWKH'+&3
setting of the computer.
2) Select SSID set for the projector by following the procedure of wireless
connection of the computer. Enter encryption key by following the computer’s
instruction if it is encrypted.
NOTE
2. Connection to the network