Hitachi P-N23NA2 - Control Settings After Sensor Installation

Air Panel
Corner
Connecting Cable
Corner Cover
with Sensor
Relay
Connector
Cable Band
Wiring Cover
Cable Band
f. Install the corner band onto the projection as shown
below.
Projection
Band
g. As you insert wiring into the corner, insert the other two
xing hooks corresponding to points Ⓐ (into the squared
slots on the air panel) and slide the corner cover in the
direction of the arrows at points Ⓐ. Then, insert the xing
hook into the squared slot (of the air panel) at point Ⓑ.
Fixing hook
Fixing hook
A
A
A
B
B
? NOTE
• Catch securely the band onto the projection. If not, the corner cover
may fall down when removing it so that may cause injury.
• Catch securely the xing hooks of the corner cover to the air panel. If
not, the xing hooks will be damaged.
6.6 CONTROL SETTINGS AFTER INSTALLING CORNER COVER WITH MOTION SENSOR
(PC-ARFG-E EXAMPLE)
Depending on the location of the corner with motion sensor,
setting on the wired controller is also necessary.
1 Press “Menu”, then “Service Installation” and enter de
Password “0-0-0-0”. Press the “Installation Menu” and the
“Test Run” menu will be displayed.
Cool
Fan Speed Louver
Menu
Service&Installation
Screen DisplaySetting
Function Menu
Menu
Help
Enter Password
OK
6 0 0 0
OK
Confirm Back
Service & Installation
Check Menu
Installation Menu
Service Menu
Back
OK
Enter
(Mon)
16:30
INSTALLATION
PMML0569 rev.2 - 07/20237
EN