Why am I getting a transmission error on my Hitachi Air Conditioner?
A transmission error in your Hitachi Air Conditioner could be due to a melted outdoor fuse or issues with the indoor/outdoor connection wiring, such as breaks or wiring errors.
Why does my Hitachi Air Conditioner show an error related to incorrect outdoor and indoor unit settings?
An incorrect setting of outdoor and indoor units on your Hitachi Air Conditioner may be caused by an outdoor/indoor unit capacity setting error or if the indoor total capacity is excessively large or small.
What does it mean when the compressor protection alarm on my Hitachi P-N23NA2 cannot be reset?
A compressor protection alarm on your Hitachi Air Conditioner that cannot be reset from the remote controller indicates that alarm codes 02, 07, 08, 39, 43 to 45, or 47 have been triggered three times within six hours.
What causes an indoor unit number setting error on my Hitachi P-N23NA2 Air Conditioner?
An indoor unit number setting error on your Hitachi Air Conditioner occurs when indoor units with the same number exist in a refrigerant piping system.
What causes the indoor RA fan protection device to activate on my Hitachi KP Air Conditioner?
The indoor RA fan protection device on your Hitachi KP Air Conditioner may activate due to fan motor overheating or locking.
What causes the indoor OA fan protection device to activate on my Hitachi KPI or DX-KIT2 Fan Air Conditioner?
The indoor OA fan protection device on your Hitachi KPI or DX-KIT2 Fan Air Conditioner might activate because of fan motor overheating or locking.
What does abnormal transmission between PCB1 and PCB2 mean for my Hitachi P-N23NA2 Air Conditioner?
Abnormal transmission between PCB1 and PCB2 in your Hitachi Air Conditioner can be caused by loose or disconnected connections.
What would cause a problem with the air inlet thermistor on my Hitachi KPI Air Conditioner?
A problem with the air inlet thermistor (RA for KPI) in your Hitachi Air Conditioner could be due to a loose, disconnected, broken, or short-circuited connector.
What would cause a problem with the air outlet thermistor on my Hitachi KPI Air Conditioner?
A problem with the air outlet thermistor (OA for KPI) in your Hitachi Air Conditioner could be due to a loose, disconnected, broken, or short-circuited connector.
What would cause a problem with the liquid pipe thermistor on my Hitachi Air Conditioner?
A problem with the liquid pipe thermistor in your Hitachi Air Conditioner could be due to a loose, disconnected, broken, or short-circuited connector.
General information regarding publication use, product updates, and manufacturer's responsibility.
Explanation of symbols (DANGER, CAUTION, NOTE) used to indicate hazardous situations.
Specific safety guidelines and precautions for operation, installation, and maintenance.
List and description of accessories provided with the air panel unit for installation.
Procedure to check and adjust the indoor unit height relative to the false ceiling.
Step-by-step instructions for safely removing the air intake grille from the air panel.
Detailed steps for mounting and securing the air panel onto the indoor unit.
Instructions for attaching the corner covers to the air panel after mounting.
Specific instructions for installing corner covers with sensors on model P-AP160NAE2.
Guide to configuring settings on the wired controller after sensor installation.
Procedures for making electrical wiring connections for the air panel.
Steps for removing the air filter for cleaning or replacement.
Instructions on how to clean the air filter properly.
How to reset the filter indicator light after cleaning or replacement.
General| Model | P-N23NA2 |
|---|---|
| Manufacturer | Hitachi |
| Category | Air Conditioner |
| Cooling Capacity | 2.3 kW |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R410A |
To Next Page
