Hitachi PR-38E - Page 7

English
6
Dø (mm) Code No.
25 955994
PR-25B
PR-38E
29 955995
32 955996
35 955998
38 956000
45 955154
54 955155
64 956002
79 955157
PR-38E94 956004
105 955159
○ Core bit shank
Code No. 955163
Applied to core bits above Dø 38 mm.
Code No. 956008
Applied to core bits below Dø 35 mm.
○ Center pin
Code No. 955165
Code No. 956009
for core bit Dø 32 mm and 35 mm
NOTE
Do not use it for core bit Dø 25 mm and 29 mm.
○ Drift key
(for self-drilling anchors)
(Code No. 944574)
○ Turning handle
(for self-drilling anchors)
(Code No. 944573)
○ Anchor adapter
(for self-drilling anchors)
NOTE
A turning handle is used with this anchor adapter.
Anchor size
For rotation and impact For impact
Code No. Code No.
w1/4 (No. 20) 944593 944568
w5/16 (No. 25) 944594 944569
w3/8 (No. 30) 944595 944570
w1/2 (No. 40) 944596 944571
w5/8 (No. 50) 944597 944572
○ Bull point
(for crushing)
Total length 280 mm 450 mm
Code No. 944566 944583
○ Cold chisel
(for grooving and squaring)
Total length 280 mm 450 mm
Code No. 944567 944584
○ Syringe
(for removing chips after making holes)
(Code No. 944575)
○ Cutter
(for crushing asphalt)
(Code No. 955180)
○ Rammer
(for tamping sand and gravel)
(Code No. 955181)
○ Bush hammer
(for roughing concrete and stone surfaces)
(Code No. 955183)
000BookPR-25B.indb6000BookPR-25B.indb6 2009/04/209:59:572009/04/209:59:57