Hitachi PR-38E - Rotary Hammer Safety Warnings; Specifications; Standard Accessories; Optional Accessories

5
English
ROTARY HAMMER SAFETY WARNINGS
1. Wear ear protectors.
Exposure to noise can cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Wear protective glasses to protect your eyes.
4. Properly set the bit holder.
5. Do not touch the bit during or immediately after operation.
The bit becomes very hot during operation and could
cause
serious burns.
○ Drill bit
(tapered shank, for drilling anchor holes)
Drill external diam. Code No.
11 mm 944460
12 mm 944461
14.3 mm 944462
14.5 mm 944500
PR-25B
standard accessory
17.5 mm 944463
21.5 mm 944464
○ Taper shank adapter
(for installing taper shank drill)
Drill diam.
to be used
11, 12, 14.3, 17.5 mm 21.5 mm
Code No. 944475 944476
○ Cotter (Code No. 944477)
(for taper shank adapter)
○ Core bit
(with guide plate, not applicable to cores 25 mm and
29 mm)
6. Safe operation depends on one's stable posture.
7. At the start of work, confi rm the oil supply and screw
tightening.
8. When working at a highly elevated location, pay attention
to articles and persons below.
9. Before starting to break, chip or drill into a wall, fl oor or
ceiling, thoroughly
confi rm that such items as electric
cables or conduits are not buried inside.
10. Wear a dust mask
Do not inhale the harmful dusts generated in drilling or
chiseling operation. The dust can endanger the health of
yourself and bystanders.
SPECIFICATIONS
Model PR-25B PR-38E
Voltage (by areas)* (110 V, 115 V, 120 V, 127 V, 220 V, 230 V, 240 V)
Power Input* 1050 W 1050 W
No-load speed 750 / min. 400 / min.
Full-load impact rate 3000 / min. 3000 / min.
Capacity: Drill bit
Core bit
25 mm
64 mm
38 mm
105 mm
Weight (without cord) 7.3 kg 7.5 kg
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
PR-25B
(1) Case .............................................................................1
(2) Side handle ...................................................................1
(3) Oil feeder ......................................................................1
(4) Wrench .........................................................................1
(5) Syringe ..........................................................................1
(6) Taper shank adapter .....................................................1
(7) Drill bit (tapered shank 14.5 mm) ..................................1
(8) Cotter
PR-38E
(1) Case .............................................................................1
(2) Side Handle ..................................................................1
(3) Oil Feeder .....................................................................1
(4) Wrench .........................................................................1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
○ Drill bit
(hexagonal shank, for drilling through-holes)
Drill external
diam.
Code No.
(
total length
)
280 mm
Code No.
(
total length
)
505 mm
16 mm 944465 944470
PR-25B
PR-38E
19 mm 944466 944471
22 mm 944467 944472
25 mm 944468 944473
28 mm 944495 944496
PR-38E32 mm 944469 944474
38 mm 944545 944546
000BookPR-25B.indb5000BookPR-25B.indb5 2009/04/209:59:562009/04/209:59:56